Composite Aircraft Water Heaters & FAA-PMA Replacement Parts
FAA-PMA approved replacement components for commercial, business and regional aircraft.​
Trusted Replacement Solutions Across Major Aircraft Platforms
AIRBUS · BOEING · BOMBARDIER · GULFSTREAM · EMBRAER
​Factory New · FAA-PMA Approved · EASA Support · 3-Year Warranty 
The water heater tank is made of composite material and shrouded by an aluminum housing to thermally insulate the pressurized tank and provide high heat retention while the exterior of the unit remains cooler to the touch outside. Stainless-steel water inlet fitting, located on the bottom of the tank, allows potable water to flow in a swirling action to mix with temperature controlled heated water selected by the control circuit board and sensed by temperature sensor. Unit resists freezing environment with heating elements that last substantially longer than other water heaters.

Our latest water heater design provides a 3-year warranty and increased reliability, so aircraft owner operators benefit more. 
SPECS:
OEM
​LOOP
Why Loop?
​MATERIAL
Stainless Steel
​Composite Tank
No Corrosion and No Mineral Deposits 
WATER SENSOR
No
Available
Added safety protection
HEATING ELEMENTS
Threaded
Slide On-Off
Easy to replace
​DIMENSIONS
​13.6" x 4.0"
12.9" x 4.0"
Smaller
​ELECTRICAL
​115VAC 400Hz 420W​
115VAC 400Hz 420W​
Same as OEM
​EMPTY WEIGHT
​4.0 lbs.
​3.9 lbs.
Lighter
​TEMPERATURE
Adjustable
Adjustable
​Same as OEM
​WATER CAPACITY
​1.5 quarts
1.09 quarts
Additional weight savings
​OVERHEAT SET POINT
​170F degrees
140F degrees
Lower, safer temperature
FULL TANK RECOVERY TIME
​15 Minutes
<10 Minutes
Faster recovery
Picture
VIEW TECHNICAL BROCHURES
Need a Replacement Water Heater?
​Find your aircraft application, review FAA-PMA documentation, and request a quote from a distributor.
Copyright © 1995-2026 I LoopPMA.com a Loop Aerospace Company I All rights reserved